Bond It Wood Pro Strong Flexible Wood Flooring & Parquet Hybrid Adhesive Sealant

Properties - Solvent and Moisture Free - Quick Cure and Rapid Bond Strength - Permanently Elastic - Suitable for use with Underfloor Heating Uses For the internal bonding of parquet, mosaic, oak, wood block, laminated, exotic timber and many other wood floor types to porous or non porous substrates including; screeds, chipboard, plywood, concrete and anhydrite. WOOD PRO is also compatible with substrates incorporating under-floor heating systems. Preparation All surfaces must clean, dry and free from, grease, polish, old adhesive remnants or any other contaminates that may hinder adhesion. Loose, friable or cracked areas should be repaired prior to application. The moisture content throughout the substrate should be checked by Hygrometer, ensuring that the moisture content does not exceed that recommended by the wood flooring manufacturer for the particular substrate. In particular Anhydrite levels would differ to those of concrete. The wood flooring should also be checked that the relative humidity figure falls within those recommended by the manufacturer. Note; underfloor heating systems should be turned off 48 hours before and 48 hours after application. All wood flooring should be acclimatised for several days in the room where it is to be installed. Application The application temperature should not be below +10o C and not above +30o C, materials should be acclimatised to this temperature in the intended application site prior to installation. Solid floors should have an existing DPM in place. Use the notched nozzle provided for maximum transfer. Apply the adhesive to the substrate in a triangular bead 8mm wide by 10mm high and at 250mmcentres at right angles to the length of the wood. Do not apply more adhesive than will be used within 20 minutes of application. To ensure maximum transfer of adhesive to the wood, lay into the adhesive with a slight twisting motion and tap into place. WOOD PRO will take at least 24 hours to cure assuming a temperature of 23OC at 50% RH. Cooler and / or less humid conditions will extend drying times. Wait until the adhesive has fully cured before sanding or finishing the flooring.