Bond It Mitre Bonding System Kit Activator 200ml & Superglue 50g Joint Wood Glue

Used in conjunction an almost instant bond is attained. Ideal for fine joints such as mitres where a close aesthetically pleasing joint is required. Uses Bond It MITRE KIT can be used for bonding

• MDF Chipboard
• Oak
• Pine
• All common timbers.
• PVCu
• Rubber
• Preparation

Surfaces to be bonded must be clean, dry and free from dust, grease or contaminants that may hinder adhesion. Application Spray aerosol lightly over one face of the joint and allow to dry. If possible, use on the least visible face of the completed joint. Apply adhesive to the other face and bring together immediately. Apply gentle pressure. IMPORTANT: Can be used on uPVC but over application of the accelerator can result in staining. This stain may not become visible for several hours after application. Apply to a test sample to check application level to avoid any staining on final job. Bonding Times The speed of cure varies according to the substrate to be bonded. Timber and metals will have a longer cure time than plastics and rubbers. Best results are achieved on close fitting parts with a very thin bond line. Excessive bond gaps will result in slower cure speeds. Limitations Not suitable for permanent glass bonding. Oily or greasy surfaces cannot be bonded. Olefinic or fluro polymers may require specialised bonding techniques. Storage Conditions Store in a closed upright container between 5 and 25°C in dry dark conditions. At low temperatures the shelf life will be prolonged. Keep out of direct sunlight.